KITE SPARE PARTS

1x Elasticized Landing Line; Lower section of 1X SLF Front Line. Sizes: TLC - TrimLite Cleat; RCL - Recoil CAS (Orange Stitches)

2pcs White Front Flying Lines
14m (Std) Use with 22m Rear Flying line 12m Use with 20m Rear Flying line 7m Use with 15m Rear Flying line

1x Pair 8m Lower Front Lines section

1x Set (2pcs) Rear Flying Lines SIZES: 8m, 15m, 20m, 22m (STD)

1x Cabrinha Airlock Valve

The Fusion Carbon Fuselage puts performance above all else. The Prepreg Carbon construction gives insane stiffness in a lightweight package. A longer fuselage gives a more locked-in stable ride, while a shorter fuselage increases maneuverability and tighter turning.

• Full Carbon prepreg construction
  
• SS316 M6 inserts
  
• Interchangeable fuselage for optimal performance and easy travel
  
• Recessed stabilizer mounting surface for minimal drag

Sold with spacer and landing line ring

Includes: 4x fins, 1x handle, 4x dogbone washers, 10x M6x16 screws; Fin Sizes: 30mm; 40mm; 50mm

Board Handle with M6 Mounting Screws.

QUAD FIN SET: Front L + R, Rear L + R fins, fin key

THRUSTER FIN SET: Front L + R, Center fins, fin key

Sold with spinning leash

1x Black Security Pin
010 = 10cm (used with Modular small loop)
013 = 13cm (use w/ 21cm harness loop)
015 = 15cm (use w/ 23cm STD harness loop or Modular large loop)

018 = 18cm (use w/ 26cm harness loop)

Includes 2 single pulley link, 4 pig tails and 1 bridle set.

WAIST LEASH

Surf Plate adaptor for Glide series Foils.

QR body with bottom of spinning handle. Connection point sold separately.

1x Black Control Line with black cover skin,1x Black Control Line with yellow cover skin, 2x White Control Line with white cover skin; SIZES: 2m, 5m, 10m

Recoil Black multi-bore PU tubing with top funnel, 4mm Dynema mainline, split top Spinning Handle & Transition plug

1x TrimLite Line for use on TrimLite Cleat. Includes Elastic cored line and Trim Handle

TPU LE Bladder with Airlock Valve & Sprint Valves

2021 Neil Pryde Glide HP Front Wing

Sizes: HP11, HP13, HP15, HP19, HP23

What NP has to say about the Glide Front Wings

GLIDE wings are made of pre-preg carbon layup with inner foam construction for maximum durability to weight ratio. This setup creates a natural tendency to roll into turns maintaining a nice balance during your ride.

The front wing is designed with a pronounced rounded “angle of attack” and an elliptical bend shape. While flying, this thick leading edge on the front wing naturally closes the radius of your turn, tightening it. Far back, the angled down tail wings maintain a self- stabilizing roll allowing an easy turning performance.

During this momentum, the GLIDE tail wing will always come back to a flat position, stabilizing the turn.